SMICRO LAB

From Circuit to System

We work electronics from the circuit upward — finding the fault on the board, writing the firmware that drives it, and integrating both into a system that runs.

Discuss a projectWhat we do

What we do

Four capabilities, one discipline: understanding the electronics well enough to repair it, extend it, or build on it.

  • Board-Level Diagnostics & Repair

    Fault-finding on the PCB itself — measurement, tracing, component-level repair and microsoldering.

  • Embedded Systems Development

    Firmware, embedded Linux, board bring-up, and driving real hardware from software.

  • IoT & Connected Solutions

    Monitoring, sensing and control built on proven platforms rather than starting from a blank board.

  • Custom Electronics & PCB Development

    Circuit work, prototypes and hardware adaptation — for selected projects.

From circuit to system

A problem rarely sits at one level. It might be a short on a power rail, a peripheral that never initialises, an interface that drops under load, or a design that needs adapting. We work down to the component and up to the running system, and take the problem at the level it actually lives at rather than the level that happens to be convenient.

  1. 01

    Circuit

    Rails, signals, measurements.

  2. 02

    Board

    PCB, components, rework.

  3. 03

    Firmware

    Bring-up, drivers, control.

  4. 04

    System

    Integration, testing, the working whole.

Services

For individuals with a faulty board, and for companies that need the engineering behind one.

Board-Level Diagnostics & Repair

We diagnose and repair the electronics itself, rather than swapping whole modules until something changes.

  • PCB diagnostics and component-level troubleshooting
  • Short-circuit and abnormal current-draw diagnosis
  • Power-rail and power-sequencing faults
  • Microsoldering, rework and connector replacement
  • Laptop and computer motherboards
  • Smartphone and device boards, and other electronic PCBs

This is electronic fault work. Software-only issues, cosmetic and mechanical damage, and routine module swaps are not what the lab is for.

Embedded Systems Development

If you have hardware, or a requirement and an idea, we make the system actually run.

  • Firmware and embedded software development
  • Embedded Linux and microcontroller applications
  • Board bring-up and hardware/software integration
  • Sensors, peripherals and communication interfaces
  • Device control applications and test utilities
  • Debugging across the hardware and software boundary

IoT & Connected Solutions

The right solution does not always need a new board. Where proven hardware already exists, using it gets you a working system sooner and at lower cost.

  • Monitoring and remote data acquisition
  • Sensor integration and device connectivity
  • Automation and control systems
  • Gateways and communication links
  • Proof-of-concept systems
  • Solutions built around existing development and industrial boards

Custom Electronics & PCB Development

A capability we are building, offered where the project is a good fit. We can evaluate a requirement, prototype it, or adapt hardware that already exists.

  • Circuit development and design support
  • Prototype development
  • Hardware modification and existing-board adaptation
  • PCB design support for suitable projects

Taken on for selected projects. Describe the requirement and you will get a straight answer on whether it fits.

About SMICRO LAB

SMICRO LAB is an electronics engineering lab in Nazareth. The work runs from board-level diagnostics through embedded development to system integration — the same discipline applied at different levels. Every job starts by understanding the electronics rather than guessing at it.

Discuss a project

Tell us what you have and what it needs to do. A fault description, a board, or just a requirement is enough to start.

Email

Useful to include

  • Device, board or system type
  • What the problem is, or what you want to achieve
  • Model or part number, if you have one
  • Photos of the board or the setup
  • Anything already tried

For engineering work an idea and a constraint are enough — you do not need to know the implementation before getting in touch.

Based in
Nazareth and surrounding areas
Visits by prior arrangement.